User Manual

42
USB Audio:
Enable: This setting determines whether or not HeadRush Looperboard is sending a USB audio
signal over a USB connection. Set to On to enable sending of the USB audio signal with the
selected Sample Rate. Set to Off to disable the USB audio signal. (To change the Sample Rate,
set USB Audio to Off first, select the correct sample rate, set USB Audio to On again, and
restart your DAW.)
Sample Rate: This setting determines the sample rate of the USB audio signal: 44.1 kHz, 48.0
kHz, 88.2 kHz or 96.0 kHz. Remember to select the same sample rate as the one in your DAW.
Also, set it before opening your DAW.
Input Level: This setting determines the incoming level of the USB audio signal coming from
your computer.
Mode: This setting determines what audio signal how the HeadRush Looperboard sends its
audio signal over the USB connection and how its outputs function while doing so:
• Live: The audio signal will be sent to your computer as well as to the HeadRush
Looperboard’s outputs.
• DAW: The audio signal will be sent to your computer only. The HeadRush Looperboard’s
outputs will be disabled to prevent any latency while monitoring.