Use Instructions
Table Of Contents
- Chapter 1: Introduction and Product Safety Information
- Chapter 2: Product Introduction
- Chapter 3: Headset and Application Use
- 3.1 Minimum System Requirements
- 3.2 Cybersecurity
- 3.3 First Time Setup
- 3.4 App Navigation
- 3.5 Device Association
- 3.6 Subject Information Management
- 3.7 Cleaning
- 3.8 Test
- 3.9 Help Screens
- 3.10 Headset Management
- 3.11 Firmware Upgrade
- 3.12 Charging
- 3.13 LED Indicators
- 3.14 Account Settings and Logout
- 3.15 Other Settings
- Chapter 4: Troubleshooting
- Chapter 1: NOTE: The Headset when powered off enters a sleep mode, in which the device will draw less power but still drain the battery overtime if not placed on charge. It is recommended that if the device is to be used within 2 weeks of powering off...
- Chapter 5: Legal
Instructions for Use
QSL01-001-rev8.0-A
HS01-019
Page 26 of 42
If the test is successful, a dialog box will appear notifying the user the test is complete. To continue to
the ‘Second Test’ select ‘Continue’. To cancel the second test, select ‘CANCEL’ and no results will be
recorded.
j)
On commencement of the second test, the progress bars will reset
to 0% and progress as before.
k)
App:
When both bars reach 100%, testing is complete.
Headset:
Remove the Headset from the subject by holding the rear section and asking the subject to lift up the
front section (the reverse of putting Headset on). If tight, it may be necessary to unlock the buckles and
loosen the straps.
Remove the foam cylinders and discard appropriately.