Use Instructions

Instructions for Use
QSL01-001-rev8.0-A
HS01-019
Page 31 of 42
Charging
The charger included in the packaging is the only charger approved for use with the Headset. See Section
5.2, page 37, for charger specifications.
3.12.1 Attaching Charger Blades
WARNING: Do not place blades into mains electrical socket before it is
attached to charger
a)
Select the appropriate region-specific blade. See
Figure 3-1, page 31, for the correct blade to use for
the regions: Australia, US, EU and UK.
Australia US
EU UK
Figure 3-1: Charger blades and regions
b)
Position the protruding lip of the blade (visible in Figure 3-1, page 31) as shown in Figure 3-2A, page
31, so the lip is facing in the direction of the arrow (identified in Figure 3-2A, page 31). Once
positioned, push down on the charger blade until it is locked into position (Figure 3-2B, page 31).
A B
Figure 3-2: Charger blade insertion procedure
3.12.2 Charging Process
WARNING: Use only the supplied charger to charge the Headset
a)
Ensure Headset is dry. Remove foam cylinders if any are still in the Headset.
b)
Turn off Headset by holding the power button (see Figure 2-2 J, page 10) on the Headset for 3
seconds. All indicator lights are off when the Headset is off.
NOTE: The Headset when powered off enters a sleep mode, in which the device will draw less power
but still drain the battery overtime if not placed on charge. It is recommended that if the device is to be
used within 2 weeks of powering off, that it be placed on charge to have sufficient battery for use once
powered back on.
c)
Plug charger into mains socket.
WARNING: Connect charger only to mains voltage rated for 100-240V, 50-
60Hz