Safety Information

Page 24 of 63 Report No.: CQASZ20210400194S
IEC 62368-1
Clause Requirement + Test Result - Remark Verdict
F.3.7 Equipment IP rating marking ............................. : IPX0

F.3.8 External power supply output marking P
F.3.9 Durability, legibility and permanence of marking P
F.3.10 Test for permanence of markings After test, there was no damage on
the label, the marking on the label
did not fade. There was no curling
and lifting of the label edge.
P
F.4 Instructions P
a) Equipment for use in locations where children
not likely to be present - marking
N/A
b) Instructions given for installation or initial use P
c) Equipment intended to be fastened in place N/A
d) Equipment intended for use only in restricted
access area
N/A
e) Audio equipment terminals classified as ES3
and other equipment with terminals marked in
accordance F.3.6.1
N/A
f) Protective earthing employed as safeguard P
g) Protective earthing conductor current exceeding
ES 2 limits
N/A
h) Symbols used on equipment N/A
i) Permanently connected equipment not provided
with all-pole mains switch
N/A
j) Replaceable components or modules providing
safeguard function
N/A
F.5 Instructional safeguards N/A
Where “instructional safeguard” is referenced in
the test report it specifies the required elements,
location of marking and/or instruction
N/A
G COMPONENTS P
G.1 Switches
N/A
G.1.1 General requirements N/A
G.1.2 Ratings, endurance, spacing, maximum load N/A
G.2 Relays
N/A
G.2.1 General requirements No relays N/A
G.2.2 Overload test N/A
G.2.3 Relay controlling connectors supply power N/A
G.2.4 Mains relay, modified as stated in G.2 N/A
G.3 Protection Devices
P