Installation Guide

MOUNTING LOCATION
We strongly recommend that you give some thought as
to the optimal location of your Invisia™ Corner Shelf
before installation. The following suggestions are
offered for your consideration, however, it is
recommended to consider advice from the appropriate
healthcare professional for locating any support rail.
To determine the optimal location, we recommend
holding the rail in place and walking through the
motions of a transfer (sitting, standing, reaching, etc.).
Consider the following when determining the optimal
mounting location:
1. Move mounting location to match structure behind
the wall.
2. Avoid electrical / plumbing behind the wall
3. Drill thru tile - not thru grout.
RECOMMENDED INSTALLATION LOCATION
Corner of Faucet Wall - Typically 36-60" from floor as
shown in Figure 1. If installing multiple Invisia™ Corner
Shelves, ensure space between is adequate to place
and remove items.
INVISIA™ CORNER SHELF INSTALLATION
Place a blanket down in the area that you will be
installing the Invisia™ Corner Shelf to protect the floor
from parts that may fall during installation. The proposed
mounting location must be cleaned prior to installation.
Refer to the fastener chart on page 1 to determine the
size of hole required for the appropriate wall
construction. NOTE: It may occur that one hole may be
installed into a stud, and another installed with
SnapToggle® toggle bolts.
A1. Mark the horizontal and vertical location of the
Invisia™ Corner Shelf. Use a level that spans across the
Invisia™ Corner Shelf to ensure the rail is straight as
shown in Figure 2.
A2. Use the wall plates as a locating guide and notch
the tile with center punch as shown in Figure 3. NOTE:
A light tap is all that is required for punch to make notch.
A3. Use the appropriate drill bit on the notched tile to
drill a pilot hole for the fasteners. If SnapToggle® toggle
bolts
are to be used, please see the separate installation
instructions. Continue with step A4.
A4. Fasten the Invisia™ Corner Shelf with the
appropriate fastener for wall construction, lock washer
and retaining washer for snap cap as shown in Figure 4.
NOTE: Perform a final tighten and inspection of all
fasteners. Test the installation by vigorously pulling on
the support handle of the Invisia™ Corner Shelf.
A5. Install the plastic snap caps to the plastic retainer
washers to cover the screws.
A6. Place the tray on top of the Invisia™ Corner Shelf,
pushing it against the corner. Install the rubber bumpers
on the bottom of the tray, behind the bent metal bar as
indicated by the in Figure 4. These rubber bumpers
will hold the tray in place.
Your Invisia™ Corner Shelf is now installed.
HealthCraft Products Inc., Ottawa, Ontario, Canada. Copyright 2009. Specifications subject to change without notice. Page 2 of 4
Figure 4.
WOOD
STUD
PLASTIC
RETAINER
WASHER
SNAP
CAP
FASTENER
LOCK
WASHER
Figure 1.
Level
NOT Level
Figure 3.
Figure 2.
TILE
Cement
Board
WOOD
STUD
“LIGHT TAP”
Figure 1b.
FAUCET
SIDE
BACK
Typically 36-60"
from floor.