Product Manual

P/N UM3001KL_AM_3001KL_AMX_3001KG_AM_3001KG_AMX_REV20201201

OPERATING INSTRUCTIONS (CONT)

Weighing a Patient and Taring a Known Weight / Pre-Tare

Pre-Tare can be performed within the following weight limits: 0.2 lb - 200 lb / 0.1 kg – 91 kg)

1. Wait until “0.0” appears on the display.

2. Press and hold for approximately 3 seconds. The

display will change and prompt entry of the weight value to be

tared. Use the arrow keys to enter the weight to be tared.

Press to save the tare value.

3. The scale will zero and the tare value will show as a negative

weight on the display. The word “TARE” will also appear at the

bottom center of the display along with the tare value.

4. Place the patient on the scale. The scale will automatically

deduct the tare value from the weight of the patient. The

display will show the patient’s weight. Note: When in Tare

mode the screen will not show a prompt to enter height mode.

5. The weight may be held on the display by pressing .

The scale will continue to display the patient’s weight after

they step off the scale and will remain on the display until

released or the scale is powered off. To release, press .

6. To reweigh the patient without removing them from the scale,

press .

7. To see the patient’s weight in another unit of measurement,

press and hold down . . If the scale is in LB mode, it will

convert the weight to KG. If the scale is in KG mode, it will

convert the weight to LB. Note: This function is not available if

Everlock

is engaged or the “Unit View” setting is disabled.

8. To remove the Tare, press . The word “TARE” will

disappear from the bottom of the display, and the tare value

will be cleared from the display. The scale will resume normal

operation.

Tare

Enter

Tare

Hold/

Release

Hold/

Release

Reweigh

Unit