Product Manual

4
ASSEMBL Y INSTRUCTIONS – CONTINUED
3.
Screw in the 4 hex screws with a 5mm hex driver.
4.
Plug load cell cable into the load
cell plug in base of scale (see
diagram 1a).
The base of the scale has been
designed to provide wire
management for the load cell
cable. Route the load cell cable as
shown in diagram 1b.
Diagram 1a Diagram 1b
5. Set the base/pillar assembly upright.
6.
Plug the cable labeled “SCALE” into SCALE jack in display
module. Plug the cable labeled “COM” into the COM jack in
the display module.
7.
Place the display module on top of the pillar and use the
Phillips screw to fasten the module to the pillar