Product Manual

USRINSPPR Rev 20110913
2
Assembling to a 1100KL, 2101KL or 2500KL Scale with “B” in the Serial Number
1. Determine which side of the handrail the height rod will be mounted to. For the Model 2500KL scale we
recommend mounting the height rod to the handrail side opposite the ramp.
2. Using a No. 5 metric allen wrench, remove the two screws holding the handrail to the right or left hand rail
support.
3. Place the appropriate lower bracket over the handrail mounting holes and reinstall the two screws. Note:
The right lower bracket is installed on the scale in Figure 2.
Figure 2
4. Using (2) M8 screws clamp the upper bracket halves around the handrail just below the bend. Only hand
tighten the screws for now.
5. Place the lower portion of the height rod into the upper bracket and carefully slide the height rod down onto
the lower bracket. Note: Hold open the upper bracket halves while sliding the height rod down onto the lower
bracket to prevent from scratching the height rod.
6. Fasten the bottom of the height rod to the lower bracket by lining up the hole in the bracket with the threaded
hole in the bottom of the height rod and screwing a M8 screw into the height rod from the bottom.
7. Use the remaining M8 screws to clamp the upper bracket around the height rod.
8. Tighten all screws with the allen wrench.