Owner's Manual

16. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic

on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.

Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used to

adjust the walking belt (see pages 23 and 24).

15. Attach the Left Rear Foot (41) and the Right

Rear Foot (61) to the Frame (57) as shown with

four #8 x 1/2" Screws (1).

See step 13. Discard the piece of cardboard.

Lower the Frame (57) (see HOW TO LOWER

THE TREADMILL FOR USE on page 21).

14. IMPORTANT: Before you begin this step,

make sure that you have read and followed

all the instructions in step 13.

aise the Frame (57) to the position shown.

Have a second person hold the Frame until

this step is completed.

rient the Storage Latch (58) so that the large

barrel and the latch knob are oriented as shown.

Attach the upper end of the Storage Latch (58)

to the bracket on the Frame (57) with a 3/8" x

1 3/4" Patch Bolt (6) and a 3/8" Nut (12).

Attach the lower end of the Storage Latch (58) to

the Base (91) with a 3/8" x 2" Bolt (3) and a 3/8"

Nut (12). Note: It may be necessary to move the

Frame (57) back and forth to align the Storage

Latch with the Base.

Large

Barrel

Latch

Knob