FOOD DEHYDRATOR Model: FD1218 Distributed by: Lenoxx Electronics Australia Pty Ltd 6 Oban Court Laverton North 3026 Tel: + 61 3 9267 2100 Fax: + 61 3 9267 2199 Customer Service: 1300 666 848 Email Address: lenoxx@lenoxx.com.au Web site: www.lenoxxelectronics.
IMPORTANT SAFEGUARDS FOR YOUR HEALTHY CHOICE FD1218 FOOD DEHYDRATOR When using electrical appliances, basic safety precautions should be followed, including the following: READ ALL INSTRUCTIONS BEFORE USE • Check that your house’s main voltage is the same as stated on the rating plate of the appliance before using the appliance. • Do the touch hot surfaces. Use the grips and buttons. • To disconnect, grasp plug and unplug cord from electrical outlet.
Do not clean under running water and do not immerse heat-and -ventilation unit in water during filling or cleaning. Do not insert the sieves with products dripping with water on the heat-and ventilation unit. Dry carefully before plugging in case of flooding inner electrical elements and heat-and-ventilation unit. Do not use aggressive detergents like cream, milk, paste etc. to clean heat-and-ventilation unit The appliance shall not be operated using a separate timer or separate remote device.
Getting to know your FD1218 Food Dehydrator The dryer consists of: 1. Heat-and-ventilation unit. a.Master switch (150W); B.Control light of master switch; c. Switch Ⅱ (300W); 2. Sieve. 3. Lid. OPERATION AND HANDLING ATTENTION!!! Clean the products intended for drying and distribute them on sieves making space between them, so that the airflow through the sieves does not cut out ---Put the sieves with products on heat-and-ventilation unit and cover them with the lid.
--Switch the dryer on. 1.Half-power ---press the master switch button ,the dryer shall be on in half-power mode(150W)and the control light of master switch shall go on (a). 2. Full power ---press the Ⅱ switch button, the dryer shall be on in full power mode (300W) and the control light of Ⅱ switch shall go on (b). 3.
4.If the dryer operates in half-power mode (150W) press the master switch button .The dryer shall switch off and the control light of master switch shall go off(a). 5.If the dryer operates in full power mode (300W) press the master switch button .The dryer shall switch off and both control lights shall go off (a) and (b). Heated air flows through the sieves evaporation water out of the products being dried. The time of drying depends on the content of water inside the products and their thickness, i.e.
CLEANING AND MAINTENANCE --- Clean the sieves and lid in lukewarm water with usual washing up liquids. --- Clean the base Heat- and-ventilation unit with damp cloth and dry carefully. ECOLOGY-ENVIRONMENT PROTECTION Each user can protect the natural environment. It is neither difficult nor expensive.