Installation Instructions

A. POWERING ON/OFF
1.Press and hold the BLUETOOTH BUTTON for 3
seconds and the INDICATOR LIGHT will flash BLUE 3
times .
2. The earphone will then enter automatic pairing and
the INDICATOR LIGHT will flash RED and BLUE
alternately .
4. Once connected, the INDICATOR LIGHT will flash
BLUE slowly and your earphone will be ready to use.
5. Once you complete use of your earphones, press and
hold the BLUETOOTH BUTTON for 3 seconds and the
INDICATOR LIGHT will flash RED 3 times. Your
earphones are now turned off.
B. WHILE IN USE
FOR CALLS
- Tap the BLUETOOTH BUTTON once to pick up or end
calls.
- Tap the BLUETOOTH BUTTON twice to redial the last
incoming or outgoing number.
- When there is another incoming call during a call, tap
the BLUETOOTH BUTTON once to end the original call
and receive a new call. Tap BLUETOOTH BUTTON
twice to put the original call on hold and receive new
call. Tap the BLUETOOTH BUTTON twice to alternate
between the two calls.
FOR MEDIA
- Tap the BLUETOOTH BUTTON once to play/pause
music.
- Tap VOLUME UP/DOWN BUTTON once to increase/
decrease media volume.
- Press and hold the VOLUME UP/DOWN BUTTON for
2 seconds to skip to the previous/next track.
- Press and hold the BLUETOOTH BUTTON to activate
SIRI/BIXBY/ALEXA etc ... platforms.
C. SILICONETIP FITTING PROCEDURE
1. Select the proper size ear tip to fit your ear canal according to
your best comfort.
D. BATTERY CHARGING
1.lnsert USB charging cable to an AC charger (not included) or a
computer USB port.
2.lnsert the Micro USB end into charge port.
3.The Led indicator lights up RED while the unit is being
charged. Once the battery is fully charged, the light will
turn BLUE .
4.Battery charging time is approximately 2 hours.
E. AMBIENT CONTROL
1.For Ambient Functions, ALWAYS FIT AND SECURE EARTIPS
WITH THE UNIT TURNED OFF.
2.Flip ON/OFF switch upwards to turn on ambient function. The
indicator light will illuminate GREEN when ambient function is on.
Flip the switch off when ambient function is not required.
3.The default sound level upon powering up the unit is set at safe
sound levels and provides protection from sound above 85dB
while delivering natural hearing.
4. Tap on the VOLUME UP/DOWN button to increase/decrease
the volume by an increment. 4 different volume increments are
provided above initial power on level to provide up to 5X sound
enhancement. Please beware of sound levels when volume
is increased.
5.Bluetooth and Ambient functions can be used
independently or simultaneously.
3. Enter your Bluetooth settings on your device and
connect earphones by choosing "TV HearGear BT+"
or connect to your TV HearGear Streamer
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.
IC WARNING
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes
aux RSS (RSS) d'Innovation, Sciences et Développement économique Canada.
Le fonctionnement est soumis aux deux conditions suivantes :
(1) Cet appareil ne doit pas causer d'interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles
de provoquer un fonctionnement indésirable de l'appareil.
MODEL: ERHG-BTWITHAMBIENT
FCC ID: 2AU6S-HGBTAMB
IC: 25701-HGBTAMB
MADE IN CHINA