User's Manual

35
Heat & Glo • 6000CMOD-IPI, 8000CMOD-IPI • 2241-900 Rev. i • 4/13
9
9
Appliance Preparation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
A. Vent Preparation
Figure 9.2 Remove the seal cap.
1. Remove the seal cap as shown in Figure 9.2.
2. Locate the fi berglass gasket in the manual bag. Attach
the gasket to the outer wrap using two self-tapping
screws. This creates a seal between the fi rst vent
component and the outer fi replace wrap. Figure 9.3
shows the gasket in place.
3. Secure the fi rst section of venting to the fi rebox by at-
taching to the starting collar with screws. See Figure
9.4.
Figure 9.1 Seal Cap in Position
Figure 9.3 Gasket in Place
Note: Vent attachment method varies by model.
Figure 9.4 Starting Collar
STARTING COLLAR
