Installation Guide
HearthSense
200549-06B16
CARE AND MAINTENANCE
• Keep the area around the log set clean and clear of debris.
• Occasionally, you may use a soft bristle brush to clean logs.
• Once every year a qualied agency or certied chimney sweep should examine and clean
the venting system of the replace.
ACCESSORIES
Purchase these replace accessories from your local dealer. If they can not supply these
accessories, contact customer service department for information.
EQUIPMENT SHUTOFF VALVE
For all models. Equipment shuto valve with
1/8" NPT tap. Fits 1/2" NPT pipe.
NVDWA2 - ON/OFF SAFETY PILOT
VALVE KIT
For all models. Required for propane
installation.
PILOT FLAME PATTERN
(
IF USING NVDWA2 PILOT KIT
)
Figure 11 shows a correct and incorrect pi-
lot ame patterns. The incorrect pilot ame
is not touching the thermocouple. This will
cause the thermocouple to cool, which
shuts the replace o. There should not be
excessive ames present under pilot shield.
If unit has been converted to propane gas
and the pilot injector orice has not been
replaced, there will be excessive pilot
ames. Install propane injector orice if this
is the case.
If pilot ame pattern is incorrect, as shown
• turn replace o (see To Turn O Gas to
Appliance, page 15)
• see Troubleshooting pages 17 through
18.
Notice: Do not mistake orange ames with
yellow tipping. Dirt or other ne particles
enter the replace and burn causing brief
patches of orange ame.
INSPECTING BURNERS
Figure 11 - Pilot Flame Pattern