12x8 Metropolitan Instructions

7/16 x 48 x 96"

(1,1 x 121,9 x 244 cm)

ROOF PANELS

PARTSREQUIRED:

2" (5,1 cm)

48x96"

(121,9x244cm)

3/4"GAUGE

BLOCK

GAA

Two Nails

Move to the outside edge. Using the long edge of the panel as a lever move the panel side-to-side until

the outside long edge is at 6" (15,2 cm) measurement overhanging the outer rafter (FigD).

Secure with two nails.

Youmayneedtomoveyourentireroofframetomakepanel

lineupwith6"overhangmeasurement(Fig.D).

You must square the roof by attaching one 48x96" panel at

this time. You will use the panel's long edge as a lever to bring

your roof into square.

Place the 48x96"roof panel as shown with the rough side up.

Use a gauge block to ensure the panel measures 3/4" (1,9 cm)

along the length of the rafter(Fig.A) Panel should be ush with

top edge of lower installed roof panel.

Secure with two nails.

Roofpanelsmaycauseseriousinjuryuntilsecurelyfastened.

DOOR

3/4"

(1,9 cm)

Fig.A

Gauge

Block

Flush

(15,2 cm)

NOTE: Measurement from rafter edge.

Fig.D

(15,2 cm)