Installation Guide

The top of your concrete pad
should be 1" minimium above grade.
4" Concrete pad
12"x12"
Continuous
Footing
4" Sand or Gravel
CONCRETE SLAB SITE PREPARATION
CONCRETE SLAB OR HARD SURFACE IN-
STALLATION
Measurements given on the Fig. 1 Concrete Slab Dimen-
sions illustration are 1-1/2” larger than the outside dimen-
sions of the Gazebo. You may choose to make your
concrete slab larger than the dimensions given. Step 5
shows you how to anchor your gazebo.
(Hardware not included in Kit.)
Dig out 4” of ground for concrete and 4” for sand/gravel
(per local code) so it is level. Finish digging 12” wide by
12” deep (per local code) continuous footing around the
perimeter of the pad. Use wood forms around the perim-
eter of gazebo foundation area. Use rebar as needed.
Pour concrete and make sure all points of the concrete
top are level and see Fig 2.
It is important to have a solid, at and level foundation for your Gazebo.
Carefully consider the recommendations listed below prior to creating your foundation.
Concrete Slab Dimensions
Fig.1
Fig.2
1
140-3/4"
Flat to
Flat
111"
Flat to
Flat
10' Floor
12' Floor
74"
Point to
Center
60"
Point to
Center
46"
46"
173"
Flat to
Flat
14' Floor
89-9/16"
Point to
Center
86-1/2"
Middle to
Center
46-3/8"
5