Owner's Manual
Heat Controller OWNER’S MANUAL Packaged Terminal A/C
10
SYSTEM CONFIGURATION
VENTILATION CONTROL
The ventilation control lever is located at left side of unit,
behind front panel.
NOTE: The vent door shipping hardware must be removed
before using vent control lever. See Installation Instructions.
When set at CLOSE, only the air inside the room is circulated
and ltered.
When set at OPEN, some outdoor air will be drawn into room.
This will reduce heating or cooling efciency.
Energy Tip:Keep the vent control at CLOSE. Room air will
be ltered and circulated.
ADJUSTING AIR DIRECTION
To adjust air direction from outward (default) to upward:
1. Remove front panel. See Fig. 7.
2. Remove louver screws that hold louver insert in place (from back side of front panel). See Fig. 13.
3. Turn louver insert and rotate 180°. See Fig. 14.
4. Replace louver insert.
5. Replace screws and front panel.
Fig. 12—Ventilaiton Control Location
Fig. 13—Backside of Front Panel
Fig. 14—Adjusting Louvers