INSTALLATION & OPERATION MANUAL Glass Panel Convection Heater Portable or Wall Mount IRGPH15B For Indoor Use only Heat Controller • 1900 Wellworth Ave. • Jackson MI 49203 • 517-787-2100 • www.heatcontroller.
WARNINGS This electric appliance produces convection heat and failure to follow warnings and instructions can cause a fire or injury. READ AND SAVE THESE INSTRUCTIONS! WARNING FIRE OR EXPLOSION HAZARD WARNING INSTALLATION & USE • Failure to follow safety warnings exactly could result in serious injury or property damage. To avoid property damage, personal injury or death due to electrical shock, follow all the instructions in this Installation and Operation manual. • For indoor use only.
FIXED WALL MOUNT LOCATION • This heater is designed for indoor use only. MINIMUM CLEARANCES • Do not locate the heater in front of or below a fixed socket outlet. 18" ( 450m • Comply with the minimum clearance in front of or below a fixed socket outlet as shown in Figure 1. 10" (2 2 50mm FIG. 1 ) 2 • Do not install the heater where a draft is likely to affect the temperature setting.
Glass Panel Heater Owner’s Manual Heat Controller FIXED WALL MOUNT OPTION–INSTALLATION 1. The wall brackets supplied with the heater must be used for the wall mount option 5. Slide the wall bracket down to remove it from the rear housing (Step 3). 2. The heater should be positioned observing the minimum clearances stated around the heater: 6. Fix the wall bracket securely to the wall through the (4) screw holes provided. Use wall anchors if necessary (not provided).
Heat Controller Glass Panel Heater Owner’s Manual OPERATION The power switch and control panel are located on the right side of the heater enclosure. POWER SWITCH The LED display shows in the upper right corner of the glass panel on the front of the heater. CONTROL PANEL LED DISPLAY STANDBY: The unit does not generate any heat when in STANDBY mode. All settings are saved while in STANDBY mode. • MODE BUTTON: There are four modes: LO, HI, AUTO, and STANDBY.
Owner’s Manual Glass Panel Heater Heat Controller TIMER ON button to set the timing. The heater will automatically start to heat in the AUTO mode when the set time on is reached. TIMER FUNCTION The user can set a specific time in the standby mode using the TIMER OFF and TIMER ON buttons. • TIMER OFF button: When the heater is working, press the TIMER OFF button to set the time off. The time range is 1hr to 24hr, in 1 hour increments.
Limited Express Warranty Comfort-Aire® Convection Heater LIMITED ONE (1) YEAR PARTS EXPRESS WARRANTY Heat Controller warrants all parts of the Infrared Heater to be free from defects in workmanship and materials for normal residential use and maintenance for one (1) year from the date of purchase by the original consumer. This Express Limited Warranty applies only when the Infrared Heater is installed and operated per Heat Controller installation and operating instructions for normal use.
Design, material, performance specifications and components subject to change without notice.
