Inc. Heat Pump User Manual

Owner’s Manual Room Air Heat Pump with R-410A Heat Controller, Inc.
10
Installation Instructions
INSTALL THE CASE
IN THE WINDOW
(cont.)
Adjust the leveling bolts and nuts against the
outside wall so that the case has a slight tilt
to the outside. Tighten nuts with an adjustable
wrench. Use a level; about a 1/2 bubble will
be the correct case slant to the outside.
Use a wood block (obtained locally) between
the leveling bolts and the wall if the wall is
weak or if the weight of the air conditioner
falls between the studs in the wall.
Extend the left and right accordion panels
to the vertical window sashes. Drill pilot
holes and attach the top and bottom corners
with 4 type D screws.
F
E
D
6
Type D
screw
Type D
screw
Type D
screw
Top mounting rail
Type D
screw
INSTALL SUPPORT BRACKETS
AND THE FOAM TOP WINDOW
GAS KET
Attach the s upport brackets with two
type D s crews, one on each s ide.
Cut the foam top window gasket to the
window w idth.
Stuff the foam between the glass and the
window to prevent air and insects from
getting into the room .
C
B
A
7
10
INSTALL SUPPORT BRACKETS
AND TOP WINDOW FOAM GASKET
Cut the top window foam gasket to the window
width.
Stuff the foam between the glass and the window
to prevent air from getting into the room.