Installation Guide

www.heat-fab.com [e-mail]
5 of 6 413.863.2242 800.772.0739 fax [phone]
R1207 130 Industrial Boulevard Turners Falls MA 01376
Technical Bulletin
9. Inspect Annually.
• During your annual HVAC equipment and system check, inspect the vent system. Make sure the system
has not been damaged, the vent has not been punctured and the supports are solid.
• Look for the proper slope toward a drain. Make sure drains are not clogged or pinched off, and are in the
proper place. Verify that all drain traps are properly primed.
• Inspect the termination and remove any accumulated debris.
• Properly installed and maintained, Selkirk Vent Systems will be trouble free for years.
Your Check List
 You have read the Appliance Manufacturer’s installation instructions.
 You have read Selkirk’s installation manual.
 You properly applied the correct RTV sealant, if required.
 All vent system joints are tight and secure.
 The vent system is installed with flow arrows pointing away from the appliance.
 Proper slope has been maintained.
 You have made provisions for the system to drain – when necessary.
 The vent system is supported adequately.
 You have explained the vent system to the building maintenance personnel.
This document is designed as a summary of issues to be aware of when using Selkirk’s Saf-T Vent systems. It
is not intended to take the place of the complete installation manuals that should be reviewed and followed
closely.
Further information, including complete installation manuals, is available by calling 800.772.0739. Or log onto
our Internet site at:
www.heatfab.com
.