Specification Sheet

Saf-T Vent
®
EZ Seal
130 Industrial Boulevard • Turners Falls, MA 01376
Phone [phone] • Fax [phone] • www.heat-fab.com
SINGLE WALL AL 29-4C
®
SPECIAL GAS VENT
5
Heatfab
Tee Cover— Used to cap off the male end of a tee that is installed horizontally. The combination of a tee and a tee cover
allows easy access for the periodic inspection of the vent system.
Part Number DIM - A DIM - B
Nominal Diameter Height
9317 3 2.5
9417 4 2.5
9517 5 2.5
9617 6 2.5
9717 7 2.5
9817 8 2.5
9917 9 2.5
91017 10 2.5
91217 12 2.5
91417 14 2.5
91617 16 2.5
A
B
Tee Cover
Tees, Boot Tees, & Covers:
Tee Cover with Drain Fitting — Use at the base of a tee or boot tee to drain away condensate from a vent
system. This type of tee cover may also be used on the leg of a tee that is installed horizontally, to create a drain in a horizontal
run. High temperature silicone rubber tubing is available separately from Heat-fab, see page 3.
Tee Cover with Drain Fitting
A
B
C
D
Part Number DIM - A DIM - B DIM - C DIM - D
Nominal Diameter Height Drain Diameter OD Drain Length
9317D 3 2.5 0.38 1
9417D 4 2.5 0.38 1
9517D 5 2.5 0.38 1
9617D 6 2.5 0.38 1
9717D 7 2.5 0.38 1
9817D 8 2.5 0.38 1
9917D 9 2.5 0.50 1
91017D 10 2.5 0.50 1
91217D 12 2.5 0.50 1
91417D 14 2.5 0.50 1
91617D 16 2.5 0.50 1