Specification Sheet

Saf-T Vent

EZ Seal

130 Industrial Boulevard • Turners Falls, MA 01376

Phone 800 772 0739 • Fax 413 863 4803 • www.heat-fab.com

SINGLE WALL AL 29-4C

SPECIAL GAS VENT

Heatfab

6" Length — Install vent with a continuous pitch of 1/4” per foot, sloping upward toward the termination (unless

otherwise specified by the appliance manufacturer). It is important to provide adequate support to a Saf-T Vent EZ Seal system.

Support horizontal portions of the vent system at 6-foot intervals. Vertical sections should be supported at least every 30-feet

and after every offset or transition.

Straight Lengths:

Part Number DIM - A DIM - B DIM - C

Nominal Diameter Installed Length Maximum OD

9301 3 4.5 3.4

9401 4 4.5 4.4

9501 5 4.5 5.4

9601 6 4.5 6.4

9701 7 4.5 7.4

9801 8 4.5 8.4

9901 9 4.5 9.4

91001 10 4.5 10.4

91201 12 4.5 12.4

91401 14 4.5 14.4

91601 16 4.5 16.4

12" Length— Install vent with a continuous pitch of 1/4” per foot, sloping upward toward the termination (unless

otherwise specified by the appliance manufacturer). It is important to provide adequate support to a Saf-T Vent EZ Seal system.

Support horizontal portions of the vent system at 6-foot intervals. Vertical sections should be supported at least every 30-feet

and after every offset or transition.

Part Number DIM - A DIM - B DIM - C

Nominal Diameter Installed Length Maximum OD

9302 3 10.5 3.4

9402 4 10.5 4.4

9502 5 10.5 5.4

9602 6 10.5 6.4

9702 7 10.5 7.4

9802 8 10.5 8.4

9902 9 10.5 9.4

91002 10 10.5 10.4

91202 12 10.5 12.4

91402 14 10.5 14.4

91602 16 10.5 16.4