Specification Sheet

Saf-T Vent

EZ Seal

130 Industrial Boulevard • Turners Falls, MA 01376

Phone 800 772 0739 • Fax 413 863 4803 • www.heat-fab.com

SINGLE WALL AL 29-4C

SPECIAL GAS VENT

Heatfab

5 Ft. Length — Install vent with a continuous pitch of 1/4” per foot, sloping upward toward the

termination (unless otherwise specified by the appliance manufacturer). It is important to provide adequate

support to a Saf-T Vent EZ Seal system. Support horizontal portions of the vent system at 6-foot intervals.

Vertical sections should be supported at least every 30-feet and after every offset or transition.

Straight Lengths:

Part Number DIM - A DIM - B DIM - C

Nominal Diameter Installed Length Maximum OD

9360 3 59.5 3.4

9460 4 59.5 4.4

4 Ft. Length — Install vent with a continuous pitch of 1/4” per foot, sloping upward toward the termination (unless

otherwise specified by the appliance manufacturer). It is important to provide adequate support to a Saf-T Vent EZ Seal system.

Support horizontal portions of the vent system at 6-foot intervals. Vertical sections should be supported at least every 30-feet

and after every offset or transition.

Part Number DIM - A DIM - B DIM - C

Nominal Diameter Installed Length Maximum OD

9308 3 46 3.4

9408 4 46 4.4