Specification Sheet

Saf-T Vent
®
EZ Seal
130 Industrial Boulevard • Turners Falls, MA 01376
Phone [phone] • Fax [phone] • www.heat-fab.com
SINGLE WALL AL 29-4C
®
SPECIAL GAS VENT
20
Heatfab
Roof Flashing— Standard roof flashings available from local plumbing suppliers may be used on Saf-T Vent EZ Seal
systems with vertical terminations. To properly support the system separate supports may be required above or below the roofline.
Pitched Cone Flashing— For use with single-wall or double-wall Saf-T Vent systems with vertical terminations. Can
be used on roofs with a 2/12 - 8/12 pitch. This part comes with a tall storm collar and is made of all stainless steel construction. On
single wall Saf-T Vent applications the roof must be of non-combustible material. For sizes larger than 6" diameter the CI Plus Tall
Cone Flashing can be used if the roof is of non-combustible material.
Pitched Cone Flashing
A
18°
1.8
12.0
0
B
Part Number Vent DIM - A DIM - B DIM - C
Diameter Top of Cone Face Plate Overall Height
Opening Square
5381CI 3 4.5 25 12
5481CI 4 5.5 26 12
5581CI 5 6.5 27 12
5681CI 6 7.7 28 12
Thimbles & Penetrations:
23.5
A
Vertical Support Leg — For use on vertical systems to provide support. The 20-gauge stainless steel support legs can
be used below or above the roof, and can be used in pairs for extra stabilization. Hardware to attach the support to the structure
is not provided; attach using best construction methods. Be sure to consider clearances when planning
the system. Never drill or screw through the Saf-T Vent vent conduit.
May be also used horizontally.
Part Number DIM - A
Hose Clamp Diameter
93VSL 3.5
94VSL 4.5
Supports:
Tall Cone Flashing— For use with single-wall or double-wall systems with vertical terminations. Can be used on flat
roofs or slightly pitched roofs. This part comes with a tall storm collar and is of all stainless steel construction. On Saf-T Vent single
wall applications the roof must be of non-combustible material. For sizes larger than 7" diameter the CI Plus Tall Cone Flashing can
be used if the roof is of non-combustible material.
Part Number Vent DIM - A DIM - B DIM - C
Diameter Top of Cone Face Plate Overall Height
Opening Square
5382CI 3 4.0 24 12
5482CI 4 5.0 25 12
5582CI 5 6.0 26 12
5682CI 6 7.0 27 12
5782CI 7 8.0 28 12
Tall Cone Flashing
12.00
B
A