Specification Sheet

Saf-T Vent
®
EZ Seal
130 Industrial Boulevard • Turners Falls, MA 01376
Phone [phone] • Fax [phone] • www.heat-fab.com
SINGLE WALL AL 29-4C
®
SPECIAL GAS VENT
26
Heatfab
Termination Accessories:
Storm Collar — For use on horizontal or vertical systems when a Heat-fab wall or roof penetration is not used or is not
required. The storm collar may be tightened and sealed around the vent to prevent water from entering the building. It may also
be used as a decorative shield to cover holes where the vent penetrates interior concrete and masonry walls. This part is made
from Type 304 stainless steel and should not be installed in the direct path of flue gases.
Part Number DIM - A
Nominal Diameter
4326SS 3
4426SS 4
4526SS 5
4626SS 6
4726SS 7
4826SS 8
4926SS 9
41026SS 10
41226SS 12
41426SS 14
41626SS 16
A
Storm Collar
Part DIM - A
Number Nominal Diameter
9392 3
9492 4
9592 5
9692 6
9792 7
9892 8
9992 9
91092 10
91292 12
91492 14
91692 16
Screen Termination —
Use as a termination on horizontal or vertical systems, as specified or allowed by the
appliance manufacturer.
Screen Termination
SCREEN
1.25
INSTALLE
D
LENGTH
A