Installation Guide

12
Joint Assembly Instructions for Rotating Clamp:
The rotating clamp allows you to position fittings in the desired flow direction of the breeching
layout. Follow these instructions for Elbows, Boot Tees, Increasers and In-Line Drains, that all
utilize the rotating clamp.
Tabs
Outside Coupler
Band
Locking Strap
Rotating Clamp
1. Begin by removing the Locking Strap and Coupler Band from the vent.
Groove for Rotating Clamp
2. Wipe the male and female ends clean with alcohol wipes. On diameter sizes without the gasket,
at 3/4" from the edge, apply a 1/4" thick continuous, straight-line bead of high temperature sealant to
the inside circumference of the female end. Do not use a zig-zag pattern when applying sealant.
Smooth down the bead with a flat instrument or your moistened finger.
Apply 1/4" Bead of RTV
on Inside of Female End
See Note Above
Clean Male and Female
Ends with Alcohol Wipe
Female End
Male End
Note: Diameters 4" thru 16" are manufactured with a factory adhered seal on the inside of the female
end and will not need sealant in the joint.