Installation Guide

13
3. Insert the male end into the female end of the preceding vent piece, loosen the rotating clamp on
the male end of the fitting with a 5/16" nut driver.
Loosen Rotating Clamp
Rotating Clamp
4. Line up the tabs of the rotating clamp with the female end of the preceding vent. Insure the beads
on the tabs of the rotating clamp are nested into the groove on the male end. RE-tighten the rotating
clamp. If needed use pliers or vice-grips to squeeze together the tabs so they will accept the slots
in the locking strap.
Pliers or
Vice-Grips
Line Up Tabs
Tighten Rotating Clamp