Installation Guide

17
Figure 2
Saf-T Vent CI Plus Horizontal Support For Large Diameters:
Saf-T Vent CI Plus must have supports for every six (6) feet of horizontal run and after every transition
from vertical to horizontal. For large diameters, 24"-32" use parts numbered CCM24HZS - CCM32HZS.
The support may be attached from the center bracket, figure 1 or attached to the side brackets, figure
2. Support hangers by themselves do not maintain the necessary clearances to combustible materials;
be sure to consider clearances when planning the system
. For 4"thru 24" diameters use support clamp
part number 4627SS-42627SS and attach as appropriate.
Figure 1
Support Clamp
Used in pairs to clamp around
the vent and suspend from a
single rod or cable.
Support Clamp
Used singularly as a saddle to
rest the vent in; suspend from
two rods or cables.
LARGE DIAMETER SUPPORTS
4" - 24" DIAMETER SUPPORTS