Installation Guide

18
Saf-T Vent CI Plus Rain Cap:
• Unscrew the wormgear clamp on the Rain Cap's Storm Collar.
• Remove the locking strap from the last section of vent pipe.
• Lower the Storm Collar past the clips on the last section of vent pipe.
The Storm Collar should sit approximately 1/2” down from the clip edges.
• Tighten the Storm Collar’s wormgear clamp to tighen around the vent pipe.
• Apply a high temperature silicone sealant around the clamped edge of the storm collar.
• Remove the locking strap from the Rain Cap.
• Lower the Rain Cap into the last section of vent pipe, lining up the clips.
• Attach the locking strap around the vent pipe and Rain Cap an tighten to complete the joint.
• The enlarged detail shows finished assembly.
Lower Rain Cap Attach Locking Strap DetailTighten & Seal
Storm Collar