Installation Guide

The Guy Supports can be used in four different applications:

1. To Lower a Stack Inside of a Chase

2. To Support a Stack from Below a Floor or Roof

3. To Support a Stack Above a Roof

4. To Support Horizontally

Spacing Between Supports

Diameters Spacing

4" thru 12" 20'

14" thru 18" 12'

20" thru 24" 10'

26" thru 32" 6'

Figure 1 Figure 2 Figure

Guy Support

assembled to Vent.

Guy Support Coupler

attached above and

Vent Section Coupler

attached below.

Guy Support Brackets

Saf-T Vent CI Plus Guy Support:

Guy Support Assembly:

Assemble the guy support to the vent sections as shown in the joint assembly instructions. Once

the guy support is assembled to the vent sections, figure 1, install the 5" long coupler from the guy

support so that it fits directly on top of the guy brackets. On the vent section below the guy

support, attach the 8" long coupler so that it fits up to the bottom of the guy brackets, figure 2. The

guy support is now totally enclosed with only the guy brackets protruding, figure 3. The guy lines

can be attached before or after installation of the couplers.

Locking Strap

3/8" Cable Holes

in Bracket,

4 Places

Coupler

Band