Installation Guide

26
Directly On Pitched Roof. Prepare a square or round opening per the framing chart. Apply weather-
stripping or outdoor caulk to the bottom of the cone plate. Attach the cone to the roof using common
construction methods. Flash over the cone plate and seal the fastener heads using normal roofing
requirements. When the vent pipe is in place through the Tall Cone, attach the Tall Cone storm collar
around the pipe. Apply RTV sealant around the top of the storm collar and the pipe. On the last section
of pipe before the Rain Cap, install the Ventilation Collar, ordered separately, over the air space between
the inner and outer vent pipes. Install the Rain Cap on the last section of vent per the Rain Cap
installation instructions. Position the Rain Cap Storm Collar 2" above the Ventilation Collar as shown in
the figure below.
Saf-T Vent CI Plus Pitched Roof Tall Cone Flashing
CONE PART
NUMBER
VENT
DIAM A
DIAM B
CCM04TCFP 4 8.
5
CCM05TCFP 5 9.
5
CCM06TCFP 6 10.
5
CCM07TCFP 7 11.
5
CCM08TCFP 8 12.
5
CCM09TCFP 9 13.
5
CCM10TCFP 10 14.
5
CCM12TCFP 12 16.
5
CCM14TCFP 14 18.
5
CCM16TCFP 16 20.
5
CCM18TCFP 18 22.
5
CCM20TCFP 20 24.
5
CCM22TCFP 22 26.
5
CCM24TCFP 24 28.
5
CCM26TCFP 26 30.
5
CCM28TCFP 28 32.
5
CCM30TCFP 30 34.
5
ROOF OPENING FRAMING
DIMENSIONS