Specification Sheet

14
Saf-T Vent
®
CI Plus
DOUBLE WALL AL 29-4C
®
SPECIAL GAS VENT
Heatfab Division, Selkirk Corp.
130 Industrial Boulevard • Turners Falls, MA 01376
Phone [phone] • Fax [phone] • www.heat-fab.com
Boot Tee — Use vertically or horizontally to add appliances into a common-vent system. When installed horizontally, the
male end of the tee body may be capped off with a tee cover to allow for future appliances. When used in conjunction with
a drain tee cover, the boot tee will effectively transition a vent system from a horizontal to a vertical orientation while allowing
for proper condensate drainage. The pressure drop through the tap for this fitting is equivalent to 15 feet of horizontal vent.
Both inlet connections rotate to accommodate direction changes. Each Boot Tee comes standard with a coupler, one joint
locking strap and two rotating clamps.
Boot Tees:
Part Number DIM - A DIM - B DIM - C DIM - D DIM - E DIM - F DIM- G
Out In Tap Installed Centerline Installed Nominal Diameter
Nominal Diameters Length of Tap to from Tap to Outer Jacket
Vent Pipe Outlet Outlet Centerline
CCA04BT 4 4 4 16.5 11 12.5 6.3
CCA05BT 5 5 5 17.5 11.5 13 7.3
CCA06BT 6 6 6 18.5 12 13.5 8.3
CCA07BT 7 7 7 19.5 12.5 14 9.3
CCA08BT 8 8 8 20.5 13 14.5 10.3
CCA09BT 9 9 9 21.5 13.5 15 11.3
CCA10BT 10 10 10 22.5 14 15.5 12.3
CCA12BT 12 12 12 24.5 15 16.5 14.3
CCA14BT 14 14 14 26.5 16 17.5 16.3
CCA16BT 16 16 16 28.5 17 18.5 18.3
CCA18BT 18 18 18 30.5 18 19.5 20.3
CCA20BT 20 20 20 32.5 19 20.5 22.3
CCA22BT 22 22 22 34.5 20 21.5 24.3
CCA24BT 24 24 24 36.5 21 22.5 26.3
CCA26BT 26 26 26 38.5 22 23.5 28.3
CCA28BT 28 28 28 40.5 23 24.5 30.3
CCA30BT 30 30 30 42.5 24 25.5 32.3
CCA32BT 32 32 32 44.5 25 26.5 34.3
F
E
1.50
D
1.50
A
B
E
D
C
G
Boot Tee