Specification Sheet

33
Heatfab Division, Selkirk Corp.
130 Industrial Boulevard • Turners Falls, MA 01376
Phone [phone] • Fax [phone] • www.heat-fab.com
Saf-T Vent
®
CI Plus
DOUBLE WALL AL 29-4C
®
SPECIAL GAS VENT
HANGERS
BY OTHERS
CLAMP
HORIZONTAL
SUPPORT
Support Clamp — Typical for smaller diameter support. For use on horizontal systems to provide support at the
required 6-foot intervals. Support clamps by themselves do not maintain the necessary clearances to combustible materials; be sure
to consider clearances when planning the system. Support clamps are sold in pairs, with two half-shells, and two 1/4-20 nuts and
bolts. This part is made from 18-gauge Type 304 stainless steel and should not be installed in the direct path of flue gases.
Can also be used as guy support clamps, vertically as well as horizontally.
Part Number Inner DIM - A
Vent Nominal Diameter
4627SS 6 8
4727SS 5 7
4827SS 6 8
4927SS 7 9
41027SS 8 10
41127SS 9 11
41227SS 10 12
41427SS 12 14
41627SS 14 16
41827SS 16 18
42027SS 18 20
42227SS 20 22
42427SS 22 24
Support Clamp
Used in pairs to clamp around
the vent and suspend from a
single rod or cable.
Support Clamp
Used singularly as a saddle
to rest the vent in; suspend
from two rods or cables.
A
A
Horizontal Support for Large Diameter — Typical for large diameter support. Provides horizontal
support for the Saf-T Vent CI Plus system. Diameters 24" thru 32" must have support every 6 feet of horizontal run. The support
may be attached from the center of the bracket or from the sides
of the support bracket. Support hangers by themselves do not
maintain the necessary clearances to combustible materials; be
sure to consider clearances when planning the system.
Support Hangers:
CLAMP
HANGERS
BY OTHERS
HORIZONTAL
SUPPORT
Center Attached Support
Side Attached Support
Part Number DIM - A DIM - B
Inner Vent Diameter Outer Jacket
CCM24HZS 24 26.3
CCM26HZS 26 28.3
CCM28HZS 28 30.3
CCM30HZS 30 32.3
CCM32HZS 32 34.3
A
A
B
B