Specification Sheet

35
Heatfab Division, Selkirk Corp.
130 Industrial Boulevard • Turners Falls, MA 01376
Phone [phone] • Fax [phone] • www.heat-fab.com
Saf-T Vent
®
CI Plus
DOUBLE WALL AL 29-4C
®
SPECIAL GAS VENT
Tall Cone Flashing and Support— Use as a vertical roof penetration/support in conjunction with a combus-
tible chase. Can be used with a roof curb if needed. Can be used on metal roofs with a 2-12 pitch. This part comes with a
storm collar and support screws and is of all stainless steel construction. A Vented Termination Collar must be used when
installed in a combustible chase and must be ordered separately. CAUTION: the support screws can only be installed with
Saf-T Vent CI Pus venting.
Supports:
Part Number Inner Vent DIM-A DIM - B DIM - C DIM - D DIM-E
Diameter Top of Cone Bottom of Cone Face Plate Overall Quantity
Opening Opening (Square) Height of Holes
CCM04TCF 4 6.5 9.75 18 12 4
CCM05TCF 5 7.5 10.75 20 12 4
CCM06TCF 6 8.5 11.75 20 12 4
CCM07TCF 7 9.5 12.75 22 12 4
CCM08TCF 8 10.5 13.75 22 12 4
CCM09TCF 9 11.5 14.75 24 12 4
CCM10TCF 10 12.5 15.75 24 12 4
CCM12TCF 12 14.5 17.75 26 12 4
CCM14TCF 14 16.5 19.75 28 12 6
CCM16TCF 16 18.5 21.75 30 16 6
CCM18TCF 18 20.5 23.75 32 12 6
CCM20TCF 20 22.5 25.75 34 12 6
CCM22TCF 22 24.5 27.75 36 12 6
CCM24TCF 24 26.5 29.75 38 12 8
CCM26TCF 26 28.5 31.75 40 12 8
CCM28TCF 28 30.5 33.75 42 12 8
CCM30TCF 30 32.5 35.75 44 12 8
CCM32TCF 32 34.5 37.75 46 12 8
Tall Cone Flashing and Support
Ø.25
SPACED
HOLE
EQUALLY
E
D
B
A
C