Installation Guide

Support Clamp, (4_ _27SS): Support clamps are sold in pairs and can be clamped around the vent and

suspended from a rod or cable. They can be used singularly as a saddle clamp to rest the vent in and

suspended from two rods or cables.

Support Legs Rotated Horizontally: Support legs can be used on horizontal runs by rotating the

clamp at the rivet connection. The legs can be cut to shorter lengths if necessary.

Rotate Clamp

Support Clamp

Support Legs

Vertical Supports, (SC_ _VSL):

Vertical support legs can be used above or below a structure for support. To install, slide the support

clamp over the end of the vent section, leaving the clamp loose. Position the support legs and install 2

screws through each leg into the structure. Tighten the clamp around vent pipe. The legs can be cut to

shorter lengths if necessary and can rotate around the support clamp at the rivet connection. By rotating

the clamp to a horizontal position the support legs can be used on horizontal runs.

Clamp

Around Vent

Screw to Structure

Vertical Support Legs