Installation Guide

16
PI-SCINS 012606
130 Industrial Boulevard • Turners Falls, MA 01376
Phone [phone] • Fax [phone] • www.heat-fab.com
SAF-T VENT SC
LIMITED WARRANTY
Heat-fab, Inc. warrants to the original consumer that the Saf-T Vent SC will be free from defects in
material and manufacturer’s workmanship when properly installed pursuant to the manufacturer’s
installation instructions and in accordance with national and local building codes. Any defect arising
from the improper installation, operation, or maintenance of this system and/or connected appliance(s)
is NOT covered by this warranty.
In order to obtain warranty service, the consumer must give prompt written notice of any defect to
Heat-fab, Inc. within ten (10) years from the date of manufacture.
The sole responsibility of Heat-fab, Inc. shall be to replace those parts of Saf-T Vent SC found to be
defective upon authorized return F.O.B. to Heat-fab, Inc., 130 Industrial Blvd., Turners Falls, MA
01376.
Heat-fab, Inc. shall not be responsible for the cost of inspecting, removing, or reinstalling the parts
subject thereto, nor shall it be liable for any special, incidental, or consequential damages or expenses
incurred by the consumer or its contractors. The warranty on any replacement parts shall be for the
unexpired term of the original warranty.
This warranty gives the consumer specific legal rights, in addition to any other rights which may
pertain and may vary from state to state.
• Normal operation of gas burning appliances does not result in deposits of combustible soot in venting
systems. However, a poorly adjusted or malfunctioning appliance can deposit soot and other debris
which can enter the vent system. As with all vents, the Saf-T Vent SC system should be inspected at
least annually for the presence of deposits of soot or debris. Any such accumulation should be removed
and the appliances adjusted to eliminate future accumulation.
• The system should also be inspected at least annually for signs of leakage of condensate or
combustion by-products at all joints. If any leakage is found the connected appliances should be turned
off and the leaks repaired.
• If the system incorporates a drain hose from either an in-line fitting or from a drain tee then the hose
must be inspected periodically to assure that water remains in the trap loop. If a proper trap loop is not
maintained exhaust from the connected appliances may accumulate in the building area.
Maintenance Procedures: