Installation Guide

1. Before joining the sections or fittings together, use an alcohol pad to wipe the joint area of both ends

of the inner pipe. This will remove any foreign matter which may affect the integrity of the seal. Install the

system with the female ends (ends with the red seal) pointing away from the appliance. (Unless specified

differently by the appliance manufacturer.)

2. Insert the male end of the inner pipe into the female end of the previous section. In extremely dry

conditions it may be helpful to moisten the seal with clean water prior to assembly. Push firmly until the

outer jacket has made contact with the snap ring located inside the female end of the previous section.

When fully assembled the outer female end will overlap the male end 1".

Joint Assembly Instructions:

Wipe Ends With

Alcohol Pads

Outer Vent

1" Overlap

Install

Self -Tapping

Screws

Male End

Female End

3. Use the self-tapping screws provided to connect the outer vents. No pre-drilling is required. CAUTION:

Do not overtighten. If using a variable torque drill, use a low torque setting to install screws, as not to

strip out the holes. If a hole becomes stripped due to overtightening, a larger diameter screw (1/2" long

max.) or short pop rivet can be used.

Female End

Snap Ring