Owner manual
Heat & Glo • TiaraE• 4035-822 Rev F • 01/05
11
C. Replacing the Light Bulbs
Burn Risk
Light bulbs are hot during operation of the
stove.
• Allow bulbs to cool at least five minutes
before touching them.
CAUTION
The light bulbs need to be replaced when the flame and/or
ember bed is dark on one side. Replace the bulbs with 75
watt halogen bulbs with mini-candelabra base. Do not
exceed 75 watts per bulb. Light bulbs can be purchased at a
local hardware or lighting store, online or by phone. To order
online, log onto www.lite-house.com or call 1-800-838-0977.
We recommend you use Sylvania model 75Q/CL/MC/RP or
Satco® model S3157.
• Turn off the circuit breaker or unplug the stove before
replacing the light bulbs.
• Light bulb access is on the bottom front of the stove.
• Locate and remove the three screws. See Figures 7.2 and
7.3.
• Lower the cover plate to access the light bulbs.
• Carefully remove the burned out bulb from the light socket.
Place the new bulb in the socket. Follow directions on
the light bulb package for handling requirements.
• Reinstall the cover plate. Make sure all wires are back
inside the stove.
• Reinstall the three screws removed earlier.
• Plug the stove’s power cord into the electrical outlet and
turn the switch to “ON”.
Handle glass assembly with care.
When cleaning glass door:
• Avoid striking, scratching or slamming
glass.
• Do NOT use abrasive cleaners.
• Do NOT clean glass when it is hot.
CAUTION
Bulbs
Sockets
Figure 7.3 Replacing the Bulbs
"OTTOMOFSTOVE
FRONT
"ULB!CCESS0LATE
2EMOVETHESETHREESCREWS
$ONOTREMOVE
THESEFOURSCREWS
BACK
Figure 7.2 Screws on Bulb Access Plate