Owner manual

Heat & Glo • TiaraE• 4035-822 Rev F • 01/05
7
Sharp Edges
• Wear protective gloves and safety glasses
during installation.
CAUTION
4
Electric Stove Set Up
A. Leg Leveling System
• Thread allen bolts through nuts until flush. See
Figure 4.1
• Slide assembled nuts and bolts into the slot on the legs
with the nuts on the bottom. Use a 5/32 in. (3.96 mm)
Allen wrench to adjust legs to the desired level. See
Figure 4.2.
Figure 4.1 Leveling Legs Components
Figure 4.2 Assembled Leveling Legs
Note: Two allen bolts and two nuts are included in the
component bag.
Shock Risk
Improperly grounded outlets could cause
electrical shock.
• Always use properly grounded, fused and
polarized outlets.
• Always use ground fault protection where
required by electrical code.
WARNING
B. Plug into Outlet