user manual

Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. A • 6/06
37
Appliance Setup
12
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
C. Accessories
Install approved accessories per instructions included with
accessories. See Service Parts List for appropriate acces-
sories. Refer to Section 16.
Shock or fire risk.
Use ONLY optional accessories approved for
this appliance.
• Using non-listed accessories voids warranty.
• Using non-listed accessories may result in
a safety hazard.
• Only Hearth & Home Technologies
approved accessories may be used safely.
WARNING
Figure 12.1
Heat-Zone/Heat-Duct Kits
• Remove the knockout from the sides of the appliance
and discard it (see Figure 12.1).
NOTE: Center the duct collar around the exposed hole
and attach it to the appliance with 3 screws BEFORE
final positioning of the appliance.
• Heat-Zone: Determine the location for the air register/
fan housing assembly.
• Heat-Duct: Determine the location of the entry in the air
duct system.
• Reference the Heat-Zone/Heat-Duct Kit instructions for
the remaining installation steps.
D. Ember Placement
• Follow ember placement instructions
in manual.
• Do NOT place embers directly over
burner ports.
• Replace ember material annually.
Explosion Risk.
WARNING
Improperly placed embers interferes with proper burner
operation.
Placing the Ember Material
Ember material is shipped with this gas appliance. To place
the ember material:
• There are two types of ember shipped with the unit.
Embers for the burner surface and Mystic Embers for
the floor of the unit.
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• When placing Glowing Embers
®
onto the burner care
should be taken so that the ports are not covered. Place
the dime-size ember pieces in front and behind of the
port trail, but not on or in between the ports (see Figure
12.2). Failure to follow procedure will likely cause light-
ing and sooting problems.
Figure 12.2 Placement of Embers
• Place Mystic Embers on the floor of unit.
• Save the remaining ember materials for use during appli-
ance servicing. The embers provided should be enough
for 3 to 5 applications.
HEAT-ZONE/HEAT-DUCT
KNOCKOUT
EMBER PLACEMENT