Gas Heater User's Manual

August 1, 2008
Page 35
Heat & Glo · Tiara Petite B · 7026-101K
Figure 8.16 With the cast iron front of the appliance removed,
remove the decorative cover located under the appliance.
To remove the cover, remove the two screws on the front
of the appliance that hold the cover in place. Pull the cover
forward, down and out.
Figure 8.17 Attach the snap disc bracket to the stud located
under the left side of the appliance using the 10-32 nut also
located in the appliance component bag.
Figure 8.18 Install the speed control (rheostat). The speed
control mounts to the decorative cover removed in Step 5.
Insert the stem of the speed control through the hole located
on the right side of the cover. Secure with the pal nut using
an 11/16 in. (17.5 mm) wrench. Attach the black and white
wires routed under the appliance indicated in Figure 8.13,
on page 34, to the two speed control wires. Push the speed
control knob onto the stem and re-attach the decorative
cover. Secure the wires up and out of the way using the zip
tie provided.
Plug in the blower.
The blower will not run until the appliance has heated up
enough to activate the snap disc. This can take up to 15
minutes depending on the temperature of the room. Likewise,
the blower will not automatically turn off until the appliance
has cooled off enough to turn off the snap disc.
Turning the control knob to the left (counterclockwise) until
you hear an audible click will turn the blower "OFF". Turning
the control knob to the right (clockwise) until you hear a click
will turn the blower "ON". Turning the control knob further to
the right will reduce the speed of the blower.