HEAT WAVE MC WW13014 Barrington Infrared Tower Heater User Manual SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If you are assembling this unit for someone else, give this manual to him or her to read and save for future reference. CM C US INTERTEK 4001358 Allen Group Int’l Inc. 377 South Lemon Ave, Suite A Walnut, CA USA 91789 L2045 FEB 2014 Call 1-877-744-3649 for assistance or email us at service@phoenixinno.
HEAT WAVE 1 MC MC IMPORTANT SAFETY INSTRUCTIONS Quick Reference Guide ! CAUTION: BEFORE OPERATING THIS EQUIPMENT, PLEASE READ THESE INSTRUCTIONS CAREFULLY. READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE ! SA 1965 CAUTION RISK OF ELECTRICAL SHOCK DO NOT OPEN NO USER-SERVICEABLE PARTS INSIDE HIGH TEMPERATURE SA 1965 KEEP DRAPERY AND OTHER FURNISHINGS AT LEAST 3 FEET / .9 METER FROM THE FRONT AND SIDES OF THE ELECTRICAL HEATER. WARNING: 1.
HEAT WAVE 2 MC IMPORTANT SAFETY INSTRUCTIONS: WARNING: Any use of this appliance other than that recommended by the manufacturer in this owners manual may cause fire, burns, electric shock and/or other serious injuries or death. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock and injury to persons including the following: 1. Read the manufacturers instructions completely before using this appliance. 2.
HEAT WAVE 3 MC GROUNDING INSTRUCTIONS This product must be grounded. If it should malfunction or break down, grounding provides a path of least resistance for the electric current to reduce the risk of electric shock. This product is equipped with a cord with an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
HEAT WAVE 4 MC OPERATING INSTRUCTIONS: Using the Control Panel (See Fig. 3 Below): H I J K L M N O P 72 Fig. 3 A B C D E F Using Remote Control (See Fig. 4 Below): This appliance includes a remote control. To operate the appliance using the remote control, ensure the unit is plugged in. Each remote control is shipped with a plastic tab inserted into the battery chamber to prevent damage and power loss. Pls remove by pulling on the tab out of the chamber. (See Maintenance Section).
HEAT WAVE 5 MC MAINTENANCE: ! WARNING: BEFORE CLEANING THE EXTERIOR OF THE APPLIANCE, DISCONNECT THE UNIT FROM THE POWER SUPPLY AND LEAVE UNTIL COOL. ! CAUTION: DO NOT USE ABRASIVE CLEANERS ON THE GLASS PANEL. DO NOT SPRAY LIQUIDS DIRECTLY ONTO ANY SURFACE OF THE UNIT. ! WARNING: AN AUTHORIZED SERVICE REPRESENTATIVE SHOULD PERFORM ANY OTHER SERVICING. WARNING: Before attempting to perform any maintenance on this appliance, turn all controls to the “OFF” position and unplug.
HEAT WAVE 6 MC TROUBLESHOOTING: WARNING: Turn off the appliance, unplug and let cool for at least 15 minutes before attempting to service. Only a qualified professional should attempt to service or repair the appliance. IF YOU EXPERIENCE DIFFICULTIES, PLEASE DO NOT RETURN THIS PRODUCT TO STORE For assistance with this appliance, please call our customer service department toll free at 1-877-744-3649 or e-mail us at service@phoenixinno.com.
HEAT WAVE 7 MC 1 YEAR LIMITED WARRANTY: Each and every product that we manufacture is tested prior to being shipped to retail stores. However, certain damages can sometimes occur during transportation. The following non-transferable limited warranty is extended only to the original consumer-purchaser of this Allen Group Int’l Inc. (A.G.I.) product.
