Full Product Manual
6 To see operational and troubleshooting information and videos,
go to www.hzsupport.com
210449-01
6,=('
OPEN
PRESS TO CLOSE
CARE AND CLEANING
• To prolong the original appearance, clean the light xture with clear water and a soft, damp cloth only.
• Do not use paints, solvents, or other chemicals on this light xture. ey could cause a premature deterioration of the
nish. is is not a defect in the nish and will not be covered by the warranty.
• Do not spray the light xture with a hose or power washer.
• If not to be used for several weeks, turn the unit OFF.
SPECIFICATIONS
Motion Sensing Range .........................Up to 40 ft. (12 m) [Varies with surrounding temperature].
Motion Sensing Angle .........................Up to 180°
Power Requirements .............................“D” Alkaline Batteries (4x) (not included)
Oine Operating Modes .....................TEST, OFF, and MOTION ACTIVATED
ON-Timer ............................................20 seconds (non-adjustable) (Night Only)
Test Timer ............................................5 Seconds (Day and Night)
Sensitivity (SENS) ...............................“L”, “M”, “H”
LED Lumens .......................................650
LED color temperature ........................4700K
BATTERY REPLACEMENT
1. Press the bottom tab of the wall mounting plate and
slide the light xture up and o of the mounting plate.
2. Remove the battery cover on the back of the light
xture and remove the old batteries.
3. Install four new 1.5V “D” batteries into the battery
compartment. Make sure the polarity of the batteries
is correct.
4. Replace the battery cover.
5. Place the top rear of the light xture over the wall
mounting plate and slide the xture down onto the
wall mounting plate. Slide the light xture down until
the bottom tab clicks and locks the light xture into
place.
IMPORTANT: Properly dispose of drained batteries.
Battery Cover
“D” Batteries