Motion Sensing Coach Lights Specification Sheet

2
598-1166-03
MAX
SENS
MIN
4. Set sensitivity control on back
of fixture to mid-position.
ON-TIME Switch at 1,
5, or 10 minutes
Mode Switching Summary
Flip light switch
off for one second
then back on*
* If you get confused while switching modes,
turn the power off for 1
1
/
2
minutes, then
back on. After the calibration time the con-
trol will be in the AUTO mode.
MANUAL MODE
AUTO
TEST
DualBrite
®
Dimmer Control
Light comes on dim for selected time after
dusk (Off, 3 hr., 6 hr., until dawn). If motion
is sensed, the light turns on full bright for the
ON-TIME (1, 5, or 10 minutes) then returns
to dim mode.
INSTALLATION
Estimated Installation Time: 30 minutes
Items needed for installation (not included):
• Phillips and flathead screwdrivers
• Pliers • Wire strippers/cutters
• Safety glasses • Light bulb
• Silicone caulk
For best performance, mount the fixture about
6 feet (1.8 m) above the ground.
1. Remove two nuts.
Wire
Path
Junction
Box
Screws
Fixture
Screw
Fixture
Screw
Horizontal Junction Boxes Only:
Remove ground screw and 2 fixture screws
from the mounting plate. Flip plate over.
Re-insert ground screw. Insert the 2 fixture
screws in the holes near the junction box
screw holes. Wire path must be located as
shown above.
Ground
Screw
5. Attach mounting
plate to junction box.
Wire Path
Ground Screw
3. Tighten screws
finger tight.
2. Remove
Mounting Plate.
WARNING: Turn power off at circuit
breaker or fuse.