Instructions / Assembly

2
206872-01
MAX
SENS
MIN
4. Set sensitivity control on back
of fixture to mid-position.
ON-TIME Switch at 1,
5, or 10 minutes
MODE SWITCHING SUMMARY
Flip light switch
off for one second
then back on*
* If you get confused while switching modes,
turn the power off for 1
1
/
2
minutes, then back
on. After the calibration time the control will
be in the AUTO mode.
MANUAL MODE
AUTO
TEST
DUALBRITE
®
DIMMER CONTROL
Light comes on half bright for selected time
after dusk (Off, 3 hr., 6 hr., until dawn). Selecting
OFF disables this feature. The motion sensing
features will continue to work as described in this
manual. If motion is sensed, the light turns on
full bright for the ON-TIME (1, 5, or 10 minutes)
then returns to dim mode.
INSTALLATION
Estimated Installation Time: 30 minutes
Items needed for installation (not included):
• Phillips and flathead screwdrivers
• Pliers • Wire strippers/cutters
• Safety glasses • Light bulb
• Silicone caulk
For best performance, mount the fixture about
6 feet (1.8 m) above the ground.
WARNING: Turn power off at circuit
breaker or fuse.
5. Attach mounting plate
to junction box.
Wire Path
Ground Screw
This fixture comes with a universal mounting
bracket. It is pre-assembled on the fixture to fit
the majority of junction box applications.
However, if the slots on the mounting plate do
not line up with the junction box screw holes:
1. Remove the fixture mounting screws from
the mounting plate. Note: Do not remove
the ground screw.
2. Attach ground wire “pigtail” to ground screw
on mounting plate (See Recommended
Grounding Method for additional informa-
tion).
3. Flip the mounting plate over.
1. Remove two nuts. 2. Remove
Mounting
Plate.
3. Tighten screws
finger tight.