Instructions / Assembly

3
206872-01
WIRING
One Motion Light
Two Motion Lights
Black
White
Green or
Bare
Light
Fixture
Black
White
Green
or Bare
Light
Fixture
Light
Fixture
CAUTION: DO NOT connect the RED
wire unless you want to control other
lights from the motion sensor.
Note: All wiring should be run in accor-
dance with the National Electrical Code
through conduit or another acceptable means.
Contact a qualified electrician if there is any
question as to the suitability of the system.
Connect the fixture wires to the wires in the
junction box. Twist the wires together and secure
with wire connectors.
Black to black
White to white
Recommended Grounding Method
Use a green ground “pigtail” (not provided) and
twist one end together with the bare fixture wire
and the box ground wire. Secure with a wire con-
nector. Secure the other end of the “pigtail” with
the GND screw on the mounting plate.
Wire Path
4. Rotate the mounting plate so the wire path
is on the upper right. Note: The wire path
on the mounting plate must be located as
shown below to allow the wires on the back
of the fixture to pass through.
5. Reinstall the fixture mounting screws and
attach the mounting plate to the junction
box as shown.
As Shipped Flipped and
Rotated
Wire Path
Fixture Screws
Ground Screw
Twist the junction box wires and the fixture wires
together as shown below. Secure with wire
connectors. If you have a metal junction box,
you may not need the green “pigtail”. If you are
unsure about the grounding method, consult
your local building code.