Instructions / Assembly

11598-1135-10
ENGLISH
RECEPTACLE RECEIVER
FeaturesandRatings:
• Controlupto1800Wattsofincandescentload.
• ControlstheON/OFFfunctioninlighting.
• Controlsupto15Aloads.
Installation
1. Removeexistingreceptaclefromjunctionbox,ifnecessary.
2. Connectgreenwirefromreceptacletogroundwireinjunction
box. Connect the black wire on receptacle to the load wire in
junctionboxandconnectthewhitewireonreceptacletothe
neutralwireinthejunctionbox.Connectionsshouldappearas
shown in illustration. Before installing fixture, make sure there
is no wire exposed at connections.
3. Mountreceptacleinjunctionboxwiththetwoscrews(long)
provided. Note: Verify the receptacle marked “CONTROLLED”
is on top.
4. Screw on cover plate with the two screws (short) provided.
Installing Receptacle Receiver
Receptacle
Screw
Ground Wire
(Bare or Green)
Junction Box
Receptacle
Testing and Operation
Followthestepsbelowtooperateandtestthereceptaclereceiver
using a remote control device:
1. Set the proper channel codes on both the transmitter and
receiver modules (see Code Settings).
2. Plug in the light fixture to be controlled in the top receptacle.
Note: If installed properly, the top receptacle will be marked
with the word “CONTROLLED” below it.
3. OperatetheON/OFFbuttonsontheremotetoverifyoperation.
LightshouldturnONandOFFasthe appropriatebuttonis
pressed.
Note: DIM is not available on this switch.
Controlled Outlet
Wall Plate
Screw
Wall Plate
Operation
1. Verify the power disconnect switch is in the ON (right side)
position.
2. Push the ON (top) button and release. The light should turn on
full bright. Note: If you are controlling a lamp, make sure it is
connected to the switched outlet and the lamp is switched on.
3. PushtheOFF(bottom)buttonandrelease.Thelightshould
turn off.
4. Push either the top or bottom of DIM button and release. The
light should turn on at 50% brightness (or last setting).
5. Push and release top of DIM button to increase brightness.
Push and release bottom of DIM button to decrease bright-
ness. Note: There are 5 DIM settings ranging from 15% to 90%
brightness.
6. Set desired DIM level. Note: DIM setting remembers last set-
tingused.TorecalllastDIMsettingfromONorOFF,pushand
release either the top or bottom of DIM button.
Note: The DIM setting defaults to 50% in the event of a power
failure.
NOTICE: When the wall switch receiver’s ON button is used
to turn the lights on, OFF commands sent by any transmitter
will be ignored. When the receiver’s OFF button is pushed,
the lights will go off and the receiver will once again accept a
transmitter’s ON/OFF commands.
Bulb Replacement
MovethepowerdisconnectswitchtotheOFF(leftside)position.
Replace bulb(s).
CAUTION: Do not exceed the maximum load limits
listed above.