Instructions / Assembly

4 598-1135-10
DETECT
CODES
1234
DAY
NIGHT
NIGHT
ONLY
Detect
Control
Battery Compartment
INDOOR AND OUTDOOR
WIRELESS MOTION SENSOR
Features:
• Nowiringrequired.
• Upto70feetsensingrange,180°Coverage
(Outdoor).
• Upto30feetsensingrange,150°Coverage
(Indoor).
• Adjustablesensitivity.
• Day/NightorNightonlyoperation.
• Testmode.
• Uses2AAbatteries.
• Walloreavemount(Outdoor).
• Can be mounted directlyto wall or with
mounting bracket (included) (Indoor).
• Controlsreceiversupto100feetaway.
Outdoor Wireless
Motion Sensor
Indoor Wireless
Motion Sensor
CODE
1 2 3 4
5 1 TEST
ON-TIME
(MINUTES)
MINMAX
DETECT
RANGE
DAY
NIGHT
NIGHT
ONLY
Outdoor Motion Sensor
(Rear View)
Indoor Motion Sensor
(FrontView)
Select Night or 24 Hour Mode
These sensors are able to detect motion day and night or night
only. To set the detection mode, remove battery compartment
cover by sliding the cover down. Remove batteries if necessary.
Slide the DETECT switch to either the DAY/NIGHT or NIGHT
ONLY position. Replace battery compartment cover by reversing
the above instructions.
Installing Batteries
• Beforemountingoutdoormotionsensor,removebatterycompart-
ment cover by sliding the cover down.
• Forindoor motion sensor, install batteries after sensor is in-
stalled.
Install 2 AA batteries according to polarity markings inside the
battery compartment. Replace battery compartment cover by
reversing the above instructions.
Swivel
Ball
Mount
Ball Mounting
Bracket
Ball Mounting
Bracket Screw
Tab
Rear of Sensor
Tab Slots
Attaching Ball Mounting Bracket to Indoor Motion Sensor
(Vertical Installation Shown)
Installing Indoor Motion Sensor Using Optional
Mounting Bracket
Note: Mount the indoor motion sensor so that it can be angled up or
down to give you the desired coverage above the floor level.
1. Attach ball mounting bracket to rear of motion sensor. The ball
mounting bracket is designed to mount to the rear of the sensor
in three possible directions depending upon the installation
requirements.Toattachtheballmountingbracket,followthe
steps shown below:
• Determinethebestmountingpositionofthesensorforthe
coverage desired.
• Determinethebestlocationofthewallmountingbracket.
• Insertthetabsontheballmountingbracketintothetabslots
on the rear of the sensor that best align the sensor with the
wall mounting bracket.
• Removethebatteries.
• Usingaphilips-headscrewdriver,insertmountingscrewinto
the hole in the battery compartment that aligns with the hole
on the rear of the ball mounting bracket. Tighten securely.
2. Place sensor mounting bracket against surface to be mounted
on and mark hole locations with pencil or center punch.
3. Usinga2.5mm(0.1")drillbit,drilltwopilotholesformounting
screws. If not mounting directly to wood or wood stud, drill 5
mm(0.2")pilotholesandusetheincludedwallanchors.
4. Attachindoormotionsensormountingbrackettoasturdyobject
(i.e. wall, ceiling, post, etc.) using two screws provided. Make sure
unit has an unobstructed view. Note: Attach mounting bracket
vertically if connecting to a curved surface such as a post.
5. Installmotionsensortomountingbracket.UsingaPhilips-head
screwdriver, loosen the clamp screw on the mounting bracket.
Insert swivel ball mount on sensor into mounting bracket socket