Instructions / Assembly

8 598-1135-10
T O HOT
OR LIGHT
T O HOT
OR LIGHT
T O HOT
OR LIGHT
1
BLACK
3
BLA C K
GREEN (Ground)
DIM
1
BLACK
T O HOT
OR LIGHT
4
BLACK
GREEN
(Ground)
2 RED
2
RED
3 BLACK
4 BLACK
Removing Tab In Battery Chamber
2. To remove tab from battery chamber, remove screw in access
door of remote with a small phillips-head screwdriver. Gently
pull tab out of battery chamber. Reassemble access door in
reverse order.
Tab
ON
12V
Inside of Remote Control
ON
12V
Battery
Compartment
(Type A23)
3. Push and release the ON button (left button) to turn light on or
theOFFbutton(rightbutton)toturnlightoff.Note: Red light
on remote should come on while button is depressed.
IMPORTANT: Wait 1 to 2 seconds after you press a transmitter
button before you press it again to allow the transmission to be
completed.
Note: If light does not turn on or intermittently turns on and off when
remote buttons are pushed, see Troubleshooting Guide.
Battery Replacement
TheremotecontrolrequiresatypeA2312Voltalkalinebatteryto
operate. The remote control is shipped with the battery installed.
With typical use, the battery will last approximately one year.
Remove battery when remote will not be used for an extended
period of time.
To replace the battery, follow the instructions below:
1. Turn remote control upside down.
2. Remove screw in access door of remote with a small phillips-
head screwdriver.
3. Remove access door and lay aside.
4. Remove battery. Install replacement battery. Make sure battery
is oriented properly (see illustration).
5. Reassemble access door in reverse order.
3-WAY WALL SWITCH TRANSMITTER
Important:Thisproductmustbeusedinconjunction
with the Wall Switch Receiver. 3-way circuit wiring is
requiredtoinstallandusethisproduct.
Note: If you are not familiar with electrical wiring, consult
an electrician about installation. In addition, some local
buildingcodesmayrequireinstallationbyaqualiedelectrician.
Installation
1. Select light switch to be replaced by 3-way wall switch transmit-
ter.
2. WARNING: Turn off the power to the light switch circuit
before you proceed. Do this at your circuit breaker or fuse
box.
3. Remove the existing wall plate and switch. Label the wires on
theexistingswitchaccordingtothediagraminFigure1.Note:
Typical 3-way wiring is shown. Actual wiring and wire colors
may vary.
Figure 1 - Typical 3-Way Wiring
4. Disconnect the two travel wires, wire connected to common
terminal, and the ground wire.
5. Remove the wall plate from the 3-way wall switch transmitter.
WARNING: The white neutral wires in a 3-way circuit
must run continuously through the entire circuit. If pres-
ent, do not connect a white neutral wire to either of the
3-way switch wires.
Common Terminal
(Dark Screw)
3-Way Switch
3-Way
Switch
Travel
Wire
Travel Wire