Owner's manual

-3-
598-1000-06
Tune Settings
Your Heath
®
/Zenith wireless chime has different selectable tunes: Ding (one
note), Ding-Dong (two note), or Westminster (eight note) (Available on se-
lected Heath
®
/Zenith chimes). The factory setting is for the Ding-Dong tune
(or Westminster, when available). This tune can be changed by following the
instructions below.
• Ding (one note tune)
Push Button: Add a jumper to location 8.
• Ding-Dong (two note tune)
Push Button: Remove jumper from location 8.
Chime: Remove jumper from location 8.
• Westminster (Eight note tune) (Available on selected Heath
®
/Zenith
chimes)
Push Button: Remove jumper from location 8.
Chime: Add a jumper to location 8.
Note: All models have both front and back door tune capabilities. You may
purchase any Heath
®
/Zenith wireless push button for a second entrance. We
recommend the back door use the Ding tune and the front door use the Ding-
Dong tune (or Westminster tune, available on selected Heath
®
/Zenith chimes).
Models that include two push buttons will come factory set for front and back
doors. Decals on the rear of the push button will indicate its setting.
1 2 3 4 5 6 7 8
Push Button Battery Replacement
Install an alkaline type A23 12 Volt battery. See diagram
inside push button for correct battery orientation.
* Code Settings 1-7
Must Match Both
Push Button and
Chime
Inside Push
Button
Inside Chime
Tune Setting
(Not used on
all models)
Chime Volume
Control
1 2 3 4 5 6 7 8
Tune Setting
Note: Some models might require
the use of tweezers to remove
and replace the jumpers.