Installation Instructions

Helpful Videos – www.hzsupport.com Helpful Answers – 1-800-858-8501
6
C. POSSIBLE CAUSE: Chime and push button/sensor are installed too far
apart.
C. CORRECTIVE ACTION: Locate chime closer to push button/sensor.
3. PROBLEM: Chime sounds when not intended (false triggers).
POSSIBLE CAUSE: Chime is receiving interference from another wire-
less device.
CORRECTIVE ACTION: Reset chime.
• Unplug chime.
• Ensure switch 1 on both the chime and push button/sensor is set to
OFF.
• Wait 30 seconds.
• PUSH BUTTON – Press and hold the push button within 20 seconds
after plugging in chime. When the “Ding” tune is played, the chime
memory has been erased.
SENSOR – Press and hold the “TEST” button inside the sensor within
20 seconds after plugging in chime. When the “Ding” tune is played,
the chime memory has been erased.
• To re-sync the push button/sensor and chime, unplug chime. Wait 30
seconds.
• PUSH BUTTON – Press and hold the push button within 20 seconds
after plugging in chime. When the “Ding-Dong” tune is played, the push
button is synced with the chime.
SENSOR – Press and hold the “TEST” button inside the sensor within
20 seconds after plugging in chime. When the “Ding-Dong” tune is
played, the sensor is synced with the chime.
Note: The push button/sensor and chime come synced from the factory. The
range of the wireless chime can vary with location, temperature, and battery
condition.
Regulatory Information
This device complies with Part 15 of the FCC Rules and RSS-210 of Industry
Canada. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
The user is cautioned that changes or modifications not expressly approved by
the party responsible for regulatory compliance could void the user’s authority
to operate the equipment.